Shireen Octopus 5800A User Manual download pdf (Page 13)

Firmware Guide & Configurations

This section shows how to configure the firmware of the octopus 5800 Series. Before continuing please do save any

configurations changes made to the firmware by the save settings button and reboot the device for the changes to take

effect.

(i) Basic

All the basic LAN & wireless configurations regarding IP Addresses, SSID, Wireless frequency, Channel,

Region etc are listed under the Basic Tab.

a) LAN

• By Clicking on the LAN hyperlink you can configure the LAN/Ethernet Settings of the wireless AP

according to your own requirement.

• The Settings are of two types Static and Dynamic (DHCP). These can be changed using the Get

LAN IP from drop down box.

• The IP Address field is used to give the device a static IP address if the IP type is set to Static IP

(Manual).

• In DHCP mode the device automatically allocates an IP using the DHCP spool.

• The Subnet Mask should be of the same class type as is the IP address.

• Gateway address is the IP address of the main server from which all traffic is relayed to the

access Point i.e. it could be a PC, modem or any other device that is acting as the mainstream for

the data. Please refer to the diagrams below for both Static IP and Dynamic IP Settings.

Page | 13



1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

No comments

Shireen Octopus 5800A User Manual Page 13